Some working examples of ours systems:
)
Bended samples
)
Parquet
)
Plywood bended samples
)
Plywood bended samples
)
Bended samples
)
Misc samples
)
Bended samples (Heartwood)
)
Cutted samples
AUTOMATIC PRESSING LINES FOR STRIP PANELS PRODUCTION
EILT Mod. 2200 - 2500 - 3000 - 3500 HF o OD
The standard equipment of these plants includes a preparation surface for the panels to be glued, with automatic feeding system of the glue spreading unit, a glue spreading unit controlled by motorised rolls or pneumatic pump, with working speeds between 30 and 120 m/min., a panel composition surface equipped with a press-introduction carriage, and a pneumatic press with working pressures reaching 18 kg/cm2 on the horizontal axis.
The standard dimensions of these plants, referring to the press bed, are the following:
| 2200mm. x 1300mm. | Mod. EILT 2200 |
| 2500mm. x 1300mm. | Mod. EILT 2500 |
| 3000mm. x 1300mm. | Mod. EILT 3000 |
| 3500mm. x 1300mm. | Mod. EILT 3500 |
and other dimensions are available on request.
The 1300mm depth is not binding since the vertical pressure is impressed from the top, thus allowing the plant to work in continuous cycle, the minimum working pressure is 10mm and the maximum working pressure is 80mm. The glue polymerisation system can be of the hot plate type, through water or diathermic oil heating system, or of the high frequency type, through generators of our production: the working cycle can be automatic or manual: in both cases, it is controlled by a PLC, and an operator interface allows to enter the data necessary to the cycle setting.
The lines can also be equipped with special multi-track loaders, straight or bent cut rear cutters, unloaders-stackers and automation systems for feeding and unloading with other machines.